Replacing Brinks with Vista 20p with zone expander

I’m replacing a Brinks alarm system and I have a few questions. The existing setup is all wired:

 
 

Brinks BHS-3000C panel with 3 keypads

 
 

2 int. sirens/speakers

 
 

1 ext. siren

 
 

1 ext. strobe

 
 

zone 1 – 2 doors

 
 

zone 2 – 2 int. doors

 
 

zone 3 – 7 windows

 
 

zone 4 – 1 overhead door

 
 

zone 5 – 4 overhead doors

 
 

zone 6 – 4 glassbreaks

 
 

zone 7 – 1 smoke, 1 heat

 
 

zone 8 – 1 smoke, 1 heat

 
 

Honeywell 4208u zone expander

 
 

zone 9 – 1 motion

 
 

zone 10 – 1 motion

 
 
 
 

For the new alarm, I’ve purchased:

 
 

Honeywell Ademco Vista 20p control panel

 
 

Honeywell 6160 alpha keypad

 
 

2 Honeywell 6150 fixed keypads

 
 

Honeywell 4219 zone expander

 
 
 
 

1. The panel is upstairs and the zone expander is mounted downstairs next to one of the motion detectors, and from there it’s wired to the main keypad. Can I use this same wiring setup with the new zone expander?

 
 

2. The motions are both connected to the zone expander. When I connect them to the new expander, will each need a EOL resistor?

 
 

3. Does it matter which zone/connectors the motions are connected to on the new expander? Where I mounted the new expander, I can only reach the two right most zone connectors.

 
 

4. It looks like the glassbreaks are wired/looped together. Is it ok to leave them like that when I connect them to the new alarm panel? Do I just need one EOL resistor?

 
 
 
 

Thanks,

 
 

dw

Advertisements
Replacing Brinks with Vista 20p with zone expander

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s